Inoksan BYM 052 N Mode D'emploi page 43

Note : The temperature values given in C above will be shown in corresponding Fahrenheit values when "deg" parameter F is chosen.
Open service menu : When the device is close, you can open device and enter menu by pressing and holding the buttons "P1-P2-P3" at the same time and
pressing "ON-OFF".
Service menu controls:
discharge
P1 P3 ON/OFF
P2
(DOWN) V (UP) Λ OK - SELECT SAVE-EXIT
Sample
usage:
To change NORMAL WASH time, follow the step respectively as follows;
1. When the device is close, you can open device and enter menu by pressing and holding the buttons "P1-P2-P3" at the same time and pressing "ON-OFF",
2. Use "P1-P2" orientation buttons and detect "Y2" display,
3. Press "P3" button and enter value menu,
4. Press "P1" (+), "P2"(-) buttons and change NORMAL WASH value adjusted 85 sec as default,
5. Save new value by pressing "P3" (OK) button.
6. To save the changes and exit press "ON/OFF" button and close the device.
7. Change is completed, press "ON/OFF" button, device will start with new saved parameters.
Restoring factory settings:
When the device is close, press and hold "START-STOP" and "DISCHARGE" buttons; on the display "Ft St" letter will appear.
In that way you reload default factory settings.