5. Visor
• Carefully pull out the pins on the visor from the pin holes on the helmet shell to remove
the visor (Fig. H).
• The fixing holes of the visor can be closed with the pins supplied.
Attention: The pin holes on the helmet can expand through excessive
use. In this case, the visor may no longer be used.
6. Cleaning and care
• All chemicals, paints and stickers can seriously impair the protective effect of the helmet.
• Only clean your helmet with lukewarm water, mild soap and a soft cloth.
• After every use, leave your helmet exposed to the air in order for it to dry.
• The inner pads are removable. Clean the inner padding with lukewarm water and mild
soap and then let it air dry.
7. Disposal
• Please contact your local waste disposal company for the disposal of the helmet.
Safety information
• The LED rear light is not a substitute for the light equipment stipulated by the German
standard StVZO (§ 67).
• When used correctly, the LED rear light gives better visibility. The LED backlight should not
be used during rainy weather. It cannot be guaranteed to work if it gets wet.
• Please only use the LED rear light together with this cycle helmet and always put it onto
the rotating wheel of the size-adjustment system.
• The LED rear light is only intended for personal use.
• Please make sure that, during use, the LED cannot be covered or obscured by collars,
rucksacks or movements of the head.
• The LED light can under certain circumstances come loose without this being noticed,
if it becomes caught on jackets, rucksacks or other objects.
• Please be aware that the battery of the LED light can fall out or become flat. Therefore,
check the light regularly for proper functioning.
• The batteries must not be exposed to excessive heat such as sunshine, fire or the like.
In the event that the batteries are incorrectly changed there exists the risk of explosion.
Only replace the batteries with the same or an equivalent battery type.
Bicycle helmet SP-107 / LED-rear light SP-09
LED-REAR LIGHT SP-09
7
GB
IE
NI