Sony UP-D2500 Mode D'emploi page 27

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7
Load the paper into the paper tray correctly.
Do not reuse the paper put back in step 5. Discard that paper.
Set the paper securely
under the tab
8
Remove the ink ribbon cartridge.
If there is a jammed paper, slowly pull out the paper.
If the ink ribbon cartridge cannot be removed, the printer must not be
operated. Contact your Sony service facility.
When you cannot see the jammed paper, go to step 9.
9
Open the top white cover, then the black cover.
If the paper has jammed inside, slowly pull the paper out.
If the jammed paper cannot be removed, the printer must not be operated.
Contact your Sony service facility.
10
Re-insert the removed paper tray, paper cover or ink ribbon cartridge if you
removed, then close the front panel.
11
Turn on the power of the printer.
When the ALARM indicaton does not light, you can use the printer as normal.
If the ALARM indicaton lights again, the printer must not be operated. Turn
off the power immediately and contact your Sony service facility.
Note
Do not open the top cover during printing because of mechanical hazard. If you do,
turn off the power switch of the printer.
Open this cover, too
27
Others

Publicité

Table des Matières
loading

Table des Matières