Publicité
Les langues disponibles
Les langues disponibles
Risk of damage of the product
Only use the specified type of battery/rechargeable battery!
Insert batteries/rechargeable batteries according to polarity
marks (+) and (-) on the battery/rechargeable battery and
the product.
Use a dry lint-free cloth or cotton swab to clean the contacts
on the battery/rechargeable battery and in the battery
compartment before inserting!
Remove exhausted batteries/rechargeable batteries from
the product immediately.
Functioning
The solar cell installed in the product converts sunlight into elec-
trical energy and stores it in 1 Ni-MH rechargeable battery. Switch
on the product with the ON/OFF switch
automatically light on as it begins to get dark. The in-built LED is
a very long-life and energy-saving light source. The light duration
depends on the amount of sunlight, the angle of light on the so-
lar cell and the temperature (the rechargeable battery capacity
is temperature-dependent). A vertical angle of light at tempera-
tures above the freezing point is ideal. The rechargeable battery
does not achieve maximum capacity until after several charge
7
and discharge cycles.
Preparing for use
Note: Remove all packaging materials from the product.
Installing the product
Install the product in accordance with Figures A, C, D:
1. Move the ON/OFF switch
the light on.
2. For model A, insert the lamp shade
solar light
3. For model A, place the Decorative solar light
connector
4. For model A, C, connect the product, pole
stake
with reference Fig C.
10
5. Your product is ready for use.
.
2
.
3
. The product will
4
into the ON position to switch
4
into the decorative
1
into the
2
and ground
9
GB/IE/NI
9
Publicité
