Télécharger Imprimer la page

LIVARNO home HG10602A Instructions De Montage, D'utilisation Et Consignes De Sécurité page 10

Publicité

Les langues disponibles

Les langues disponibles

Setting up the product
Insert the assembled product far enough into the ground
(lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance at all times.
Do not use any force when assembling or setting-up the
product, e.g. hammer blows. This will damage the product.
In order to achieve the best result, set the product up in a
place where the solar cell will get direct sunlight for as long
as possible.
Make sure that the solar cell is not influenced by any other
source of light such as yard or street lighting as otherwise
the light will not come on in twilight.
The light automatically switches on in twilight conditions and
off again when normal outdoor lighting conditions return.
Replacing the rechargeable battery
The rechargeable battery should be replaced every 12 months
to ensure optimum performance.
1. Switch off the light with the ON/OFF switch
2. Loosen the fastening screws
screwdriver and then lever out the decorative solar light
with the help of a slot screwdriver (see Fig. B/E).
3. Take care not to damage the cables and cable connections
(see Fig. B/E).
4. Exchange the old rechargeable battery
Take care about the correct polarity, when inserting the new
rechargeable battery. The polarity is indicated in the battery
compartment. The new rechargeable battery has to have
the same technical data like the old one.
5. Now again fasten the decorative solar light
fastening screws
driver. Slide the ON/OFF switch
Charging the rechargeable battery
Note that the product must be switched on when the rechargea-
ble battery is charging.
The charging time of the rechargeable battery when the solar cell
is used depends on the intensity of the sunlight and the angle of
incidence of the light on the solar cell. Place the solar cell as
perpendicular as possible to the angle of incidence of the light.
In this way you will receive the highest light levels.
10 GB/IE/NI
by using a small cross head
8
by using a small cross head screw-
8
.
4
to a new one.
7
, fasten the
2
to the position ON.
4
2

Publicité

loading

Ce manuel est également adapté pour:

Hg10602bHg10602c439153 2304