Federal Signal Global Serie Consignes D'installation Et De Maintenance page 17

6.
Insert the PCB into the enclosure and fully tighten the PCB captive
screw.
7.
Place the cover on the housing and tighten it by turning it clockwise.
8.
To ensure O-ring compression, the cover must be fully seated against
the housing when the threads are tightened. Turn the M3 set screw on
the side of the housing until the screw contacts the housing.
9.
Ensure that the unused wire entry is sealed with the provided brass
M20-1.5 x 6 g stopping plug (equipment-certified).
Tone (Position)
0 (0)
1 (1)
2 (2)
3 (3)
4 (4)
5 (5)
6 (6)
7 (7)
8 (8)
9 (9)
10 (A)
11 (B)
*12 (C)
13 (D)
14 (E)
15 (F)
*Factory setting
Installation and Maintenance Instructions
Table 1 Tone chart
Description
Off
Two Tone
Swept
Warble
Constant 700 Hz
Simulated Bell
Swept
Two Tone
700 Hz
Swept
Swept
1 KHz
Constant 1 kHz
Two Tone
Warble
Swept
Model G-SND Global Series Sounder
Frequency
588 Hz
714 Hz
600 Hz to 700 Hz
1000 Hz/1400 Hz
Silence
Warble
Silence
700 Hz
~ 3 rings per s
1.6 kHz to 1.2 kHz
1.2 kHz to 2.6 kHz
1 kHz
700 Hz
700 Hz
Silence
400 Hz to 1.6 Hz
Constant 1.2 kHz
1.2 kHz to 400 kHz
Silence
500 Hz to 770 Hz
1 KHz
Silence
1 kHz
700 Hz
500 Hz
1 kHz to 1.4 kHz
1.2 kHz 400 Hz
Duration
0.25 s
0.25 s
0.5 s
0.4 s
0.25 s
0.4 s
0.2 s
6 cycles per s
0.4 s
0.4 s
0.25 s
0.25 s
1 s
2 s
1 s
5 s
0.5 s
1 s
1 s
0.5 s
0.5 s
10 cycles per s
1 s
17