Federal Signal Global Serie Consignes D'installation Et De Maintenance page 16

Installation and Maintenance Instructions
For 120 Vac operation (remote switching of tones)
a.
b.
c.
d.
e.
f.
g.
For 24 Vdc operation (remote switching of tones with local power)
a.
b.
c.
d.
e.
f.
g.
For 24 Vdc operation (remote switching of tones with remote power)
a.
b.
c.
d.
16
Set the voltage selector switches to 120 and AC.
Set the tone selector switch to 0.
Connect the line (hot) power source wire to the terminal block
position marked L1 on the PCB.
Connect the neutral (common) power source wire to the terminal
block position marked L2 on the PCB.
Connect the ground wire to the terminal block position marked
EARTH.
Connect the common wire from remote switching device to the
terminal block position marked SEL.
Connect the tone select wires from remote switching device to
the terminal block positions marked T1, T2, T3, and T4.
Set the voltage selector switches to 230 and DC.
Connect the positive (+) power-source wire to the terminal block
position marked L1 on the PCB.
Connect the negative (–) power source wire to the terminal block
position marked L2 on the PCB.
Connect the positive (+) power source wire to the terminal block
position marked L1 on the PCB.
Connect the ground wire to the terminal block position marked
EARTH.
Connect common wire from remote switching device to the
terminal block position marked SEL.
Connect tone select wires from remote switching device to the
terminal block positions marked T1, T2, T3, and T4.
Set the tone selector switch to 0.
Connect the negative (–) power source wire to the terminal block
position marked L2 on the PCB.
Connect the positive (+) power source/select wires
to the terminal block positions marked T1, T2, T3, and T4.
Connect the ground wire to the terminal block position marked
EARTH.
Model G-SND Global Series Sounder