SilverCrest SURQ 4 A1 Mode D'emploi page 61

10.15 Connecting headphones
Be careful when using headphones. Listening at a high volume can damage your hearing.
You can connect headphones (not supplied) with a 3.5 mm jack connector to the headphones jack
(19). The speakers (2) are switched off if headphones are connected.
10.16 Wireless charging
Your mobile device must support the Qi standard to allow wireless charging.
Your mobile device can charge faster in standby mode than with the radio switched on.
Your mobile device must support this feature.
Proceed as follows to charge your mobile device:
•
Place your mobile device centrally on the Qi charging base (16). It will start to charge
automatically. The [
•
If you use a case for your mobile device, it can hamper the charging process. Remove the case
before charging the device.
Large mobile devices or those with smooth surfaces can sometimes slide off the Qi
charging base (16). If this happens, place the two self-adhesive silicone stoppers (C)
parallel to one another under the QI charging base (16). Stick the silicone stoppers (C)
in the marked area depending on the size of your mobile device, as shown in the diagram
below. To charge your mobile device, place it centrally on the Qi charging base (16),
touching the silicone stoppers (C) .
10.17 Charging a device with a USB charger cable
You can also charge your mobile device with a USB charger cable. Only devices with a USB A plug
charging cable can be charged. The procedure is as follows:
•
Use the original USB charging cable from the respective device manufacturer.
•
Connect the USB-A connector on your USB charger cable to the USB port (21) on the radio.
] symbol (30) is shown on the display (1) during the charging process.
SilverCrest SURQ 4 A1
English - 59