SilverCrest SURQ 4 A1 Mode D'emploi page 46

SilverCrest SURQ 4 A1
Please follow these instructions to avoid risk of potential fatal injury or fire! Never cover the power
adapter, otherwise there is a risk of fire. Never open the housing on the power adapter. This could
result in potentially fatal electrocution. Please only use the power adapter with the SilverCrest SURQ
4 A1 radio.
WARNING! Radio interface
Turn the device off when on board an aircraft, in a hospital, in an operating theatre or in the vicinity
of electronic medical equipment. The RF signals may interfere with the functionality of sensitive
devices. Keep the device at least 20 cm (8 inches) away from pacemakers or implanted defibrillators,
as the RF signals could interfere with their functionality. The RF signals transmitted can interfere with
hearing aids. If wireless mode is switched on, do not place the device near flammable gases or in a
potentially explosive area (e.g. a paint shop), as the RF signals transmitted could cause explosions
or fire. The range of the radio frequency signals depends on environmental conditions. If data is
transmitted via a wireless connection, it can also be received by unauthorised parties. Targa GmbH
is not liable for any interference caused to RF or TV signals through unauthorised modification to this
device. Furthermore, Targa accepts no liability for replacing any cables or devices that have not been
specifically approved by Targa GmbH. The user is solely responsible and liable for remedying any
interference caused by such unauthorised modification of this device or for replacing the device.
WARNING! Make sure that:
 there is free circulation of air (do not place the device on shelves, on a carpet, on a bed, or
anywhere that obstructs the ventilation slots and leave at least 10 cm clearance on all sides)
 contact with water spray and drops and aggressive fluids is avoided and the device is never
operated near water. the device is never submerged (do not place any items containing liquids,
such as drinks, vases, etc. on or near the device).
WARNING! Cables
Always handle the cables by the connector and do not pull on the cables themselves. Do not touch
the connector with wet hands. Never place heavy objects or furniture on the cables and take care
that the cable does not become trapped, especially near the plug and sockets. To avoid damaging
them, never install the cables around hot or sharp objects. Never tie knots in cables and do not tie
them to other cables. All cables must be positioned so that nobody can trip over them or be obstructed
by them.
44 - English