SilverCrest SURQ 4 A1
10.3. Adjusting the volume
When the device is switched on, you can adjust the volume from "00" (minimum volume) to "32"
(maximum volume). Press the [
(6) to lower the volume.
10.4 Selecting the mode
Press the [
] button (13) several times to toggle through the different modes. The current mode is
shown on the display (1). The following modes are available: DAB radio [
®
(36), Bluetooth
[ ] (35), and AUX mode [AUX] (38).
10.5 Setting the date and time
10.5. 1 Automatic setting via the RDS signal
The radio alarm clock has an automatic time display. The date and time are set automatically after it
is first connected to the mains. The "SYNC" indicator on the display (1) indicates that the radio alarm
clock is waiting for the date and time signal. After receiving the signal, the display (1) shows the
current time.
Due to high-frequency interference and unfavourable reception conditions, e.g. in heavily
shielded buildings, the reception of time signals may be limited or not possible at all. In
this case, you can set the time manually as described in the chapter "Manual time setting".
10.5.2 Setting the time manually
In addition to the automatic setting of the time, it is also possible to set the time manually. This can be
useful if the RDS signal cannot be received for some reason:
•
In standby mode, press and hold the [
setting switches from the current time to "24H" or "12H". Now press [ ] (3) or [ ] (9) to
switch between 12 and 24-hour mode. Confirm your selection by pressing the [
[
] button (11).
•
The hours start flashing. Set the correct hour using the [ ] (3) or [ ] (9) buttons. Confirm your
selection by pressing the [
•
The minutes start flashing. Set the correct minute using the [ ] (3) or [ ] (9) buttons. Confirm
your selection by pressing the [
50 - English
] button (5) to increase the volume or press the [
] button (15) for approx. 2 seconds until the display
] (15) or [
] button (11).
] (15) or [
] button (11).
] button
] (37), FM radio [
] (15) or
]