Publicité
Les langues disponibles
Les langues disponibles
General Installation
• Installation must conform with local codes or, in the absence of local
codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54,
Natural Gas and Propane Installation Code, CSA B149.1, or Propane
Storage and Handling Code, CSA B149.2, or the Standard for
Recreational Vehicles, ANSI A 119.2/NFPA 1192, and CSA Z240 RV
Series, Recreational Vehicle Code, as applicable.
• To check local codes, see your local L.P. gas dealer or natural gas
company listed in the Yellow Pages for recommended installation
procedures and regulations.
WARNING
This appliance is not to be installed in or on a recreational vehicle
and/or boat.
Follow these safety rules before each use:
1. A minimum clearance of 36 inches from the left, right, back and
bottom sides of the grill must be maintained between the grill and
any combustible construction such as wood siding of a building.
2. Never locate the grill under an unprotected combustible material
or overhang.
3. Do not obstruct the flow of combustion and ventilation air. Maintain
a minimum clearance of 3 inches from the back of the grill and non-
combustible construction such as a concrete or brick wall.
4. Keep the ventilation opening(s) of the cylinder enclosure free and
clear from debris.
5. The grill should be level and not facing directly into the wind.
WARNING
A liquid propane tank, not connected for use with this gas barbecue,
shall not be stored in the vicinity of this or any other appliance.
Connections must comply with local requirements and are the
sole responsibility of the person performing the work.
WARNING
• DO NOT attempt to adjust the regulator as this could
create a situation causing personal injury or property
damage.
Portable L.P. Gas Barbecue Cylinders
Liquefied Petroleum gas (abbreviated L.P. gas or propane), is highly
flammable. It becomes liquid when stored under high pressure inside a
cylinder and vaporizes when released. L.P. gas is heavier than air and
tends to collect in low areas. It is important that there are no leaking
connections on your gas grill that could cause a fire or explosion (see the
section titled "LEAK TESTING").
Portable LP gas grills require a fuel delivery system which is comprised
of a valve [A], a regulator [B] with vent hole [C], an L.P. gas supply
cylinder [D], (Fig. 1). Illustration in Fig. 1 is for description purposes only.
Cylinder Specifications
• All L.P. gas cylinders used with this appliance shall be
constructed and marked in accordance with the Specifications
for L.P. Gas Cylinders of the U. S. Department of Transportation
(DOT) or the National Standard of Canada, CAN/CSA-B339,
Cylinders, Spheres and Tubes for Transportation of Dangerous
Goods; and Commission, as applicable; and shall be provided
with a listed overfilling prevention device, if required; and a
cylinder connection device compatible with the connection for
outdoor cooking appliances.
• Read labels on the L.P. Gas Supply Cylinder.
Your new barbecue grill is equipped with a CGA # 600 regulator [B].
DO NOT attempt to connect this regulator to any other
disposable L.P. cylinder not equipped with a mating CGA # 600
fitting [E]. This grill may only be used with the pressure regulator
supplied with this unit, or pressure regulators specified by
Coleman for use with this unit. Replacement regulators must
only be those specified by Coleman.
Fig. 1
B
C
• NEVER store a spare L.P. gas supply cylinder under the grill
body or inside the grill enclosure or in the vicinity of any heat
producing appliance. (Fig. 2)
Failure to follow this information exactly could result in an
explosion and/or fire causing death or serious injury.
Fig. 2
REPRESENTATIVE ILLUSTRATION
English-3
WARNING
E
D
DANGER
A
Publicité
