Elektror HRD 1T FU Instructions De Service Et De Montage page 22

These service partners are bound by a contract with Elektror
and have been trained to service our ATEX blowers. Careful
EN
adherence to the ATEX regulations applicable throughout the
EU, but also to the specifi c requirements we have defi ned as
the manufacturer to enhance the safety of our ATEX prod-
ucts, is guaranteed by our service partners.
Deviations from the procedures required to maintain safety
and health protection or explosion protection on the part of
the customer may lead to loss of warranty and exclusion of
liability by Elektror.
As specifi ed by law, the user is responsible for safety and
health protection during operation as well as for trouble-free
operation.
According to the ATEX directive for explosion protection as
well as the regulations and standards based on it, require-
ments detailing admissible and inadmissible material com-
binations have been published. Inadmissible material com-
binations may render ineff ective any constructive measures
aimed at achieving explosion protection. This may substan-
tially increase the explosion risk entailed in ATEX products.
Spare parts list of non-explosion-protected devices must not
be applied to ATEX appliances and are therefore void.
Recommendation: Use only original spare parts provided by
Elektror as this will enable low-risk replacement.
6 SAFETY RELATED INFORMATION
ON TAKING OUT OF OPERATION AND
REMOVAL
The disconnection of all electrical connections and any
other electrical work in connection with decommissioning
must only be carried out by a qualifi ed electrician.
The device should be dismantled only when all rotating
parts have come to a standstill and cannot be restarted.
The guidelines set out in 2.1 Transport and Handling must
be observed when dismantling and removing it.
Treat the device as industrial waste when disposing of it.
The device parts are made of recyclable material, such as
aluminium, (stainless) steel, copper and plastic. However,
there are components that need special treatment (e.g.
frequency converters). The statutory national and local dis-
posal and recycling regulations must be observed.
7 LIABILITY AND EXCLUSION OF LI-
ABILITY
The owner bears responsibility for the designated use of the
unit.
Elektror shall not be liable in any case of damage resulting
from non-designated use of its units and components.
This also applies, in particular, to special usages and
application conditions, which have not been expressly co-
ordinated with Elektror.
Furthermore, Elektror shall not be liable for damage result-
ing from modifi cations or conversions to the delivered
equipment or accessories, in particular, if such changes can
impair the explosion protection.
Similarly, Elektror shall assume no liability for maintenance
work and repairs, and the possible consequences thereof,
that have been performed incorrectly, with delay, by techni-
cians not qualifi ed by Elektror, or which have not been
carried out at all.
22
Operating and assembly instructions HRD ATEX
www.elektror.com