SilverCrest SSB 70 D2 Mode D'emploi Et Consignes De Sécurité page 26

SSB 70 D2
9.3.2 "OPTICAL" mode
IMPORTANT:
The optical cable (D) connectors are protected by plastic caps on both ends. Before using the cable, these plastic caps
have to be removed to prevent damage on the soundbar or TV.
Use this operating mode to play music from the optical digital input (11) for example from a TV on your sound bar (A). The TV must have an optical digital output.
Use the optical cable supplied (Toslink cable) to make the connection. Proceed as follows:
•
Connect the Toslink cable (D) to the optical digital output of your TV.
•
Then connect the Toslink cable (D) to the optical digital input (11) of your sound bar.
•
Switch the TV set and sound bar on. Set the connected TV to "PCM Stereo" or "Stereo 2.0".
•
Start playing on the TV.
•
Press the "OPTICAL" button (15) on the remote control to select this mode.
•
You can use the volume buttons (30, 32) to adjust the volume to your requirements.
•
If you wish, you can change the audio settings using the relevant buttons on the remote control.
See the user manual for the TV set.
9.3.3 "BLUETOOTH" mode
The Bluetooth device name of the sound bar is SSB 70 D2.
If you are prompted for a PIN during the pairing process, enter "0000".
It can take a variable amount of time to establish the connection, depending on the device.
Establishing a connection
•
Press the button (16) to switch to Bluetooth mode.
After switching to Bluetooth mode, the sound bar automatically connects to a paired devices (a steady "bt" is shown on the LED display (1)) or,
if no paired device is found, automatically switches to Bluetooth pairing mode (the LED display (1) shows a flashing "bt"). If the connection to a
paired device is lost, the device switches off after approx. 10 minutes.
•
If your playback device has not yet been paired with the sound bar, the display flashes "bt".
•
Start Bluetooth scanning mode on your playback device (e.g. smartphone). It should then find the sound bar under the name "SSB 70 D2".
•
Now establish a Bluetooth connection between your playback device and the sound bar.
•
Once a connection has been established, the LED display (1) shows "bt" and a confirmation beep sounds.
Generally, you should only have to pair once as the playback device saves the name of the sound bar. This means you do not need to pair the
devices manually when you establish the connection again.
If you wish to disconnect an existing Bluetooth pairing or switch to pairing mode, press and hold the
about 1 second.
•
Now start music playback from the source device. The sound is played back via the sound bar.
•
You can use the (17),
•
You can use the volume buttons (30, 32) to adjust the volume to your requirements.
Disconnect
The Bluetooth pairing is disconnected if ...
•
... either of the devices is switched off. A confirmation beep will sound.
•
... Bluetooth is switched off. A confirmation beep will sound.
•
... the sound bar and source device are beyond the Bluetooth range (approx. 10 metres).
•
...you keep the button (16) on the remote control pressed for about 1 second.
9.3.4 "USB" mode
The sequence of the tracks/folders played is determined by the order in which they are copied to the USB stick.
In this mode, you can use the sound bar to play back audio files stored on a USB storage device, e.g. a USB stick. If connecting a USB hard drive, please
note that the maximum current on the sound bar's USB connection is 300 mA. Please also see the user manual for the USB hard drive.
24 - English
(18) and (31) buttons on the remote control or your source device to control playback.
button (16) on the remote control for