SilverCrest SSB 70 D2 Mode D'emploi Et Consignes De Sécurité page 23

7.1 Remote control
You can use the remote control supplied to control the sound bar functions. Please see the chart below for the button functions.
13 Mute
14
HDMI (ARC) Switch to HDMI ARC input
15 OPTICAL Switch to optical digital input SPDIF
16 Switch to Bluetooth
17 Play / Pause
18 Next track
19 STOP
20
TREBLE+ Amplify treble
21
BASS+ Amplify bass
22
MOVIE Enables the equalizer for movies
23
3D Enables the equalizer with simulated surround sound
24 Battery compartment (on the back)
25
DIALOG Enables the equalizer for voice playback
26
MUSIC Enables the equalizer for music
27
BASS- Attenuate bass
28 TREBLE- Attenuate treble
29 Repeat
30
VOL- Reduce volume
31 Previous title
32
VOL+ Increase volume
33 Toggle display on/off
34
USB Switch to USB input
35
AUX Switch to AUX input
36 On/Standby
8. Before you start
Remove the sound bar and all accessories from the package and remove the plastic films. Verify that you have received all items listed.
8.1 Positioning
The ideal position for your sound bar is centrally under your TV set. You can place the sound bar on a piece of furniture or mount it to the wall.
8.1.1 Wall-mounting (Figure C)
Make sure that you use suitable wall-mounting material.
Tools/mounting material needed (not included in the package):
•
Drill (depending on the wall)
•
2 screws and possibly 2 rawlplugs (depending on the wall) to fix to the wall. Please note that the screws must be suitable for the weight of the sound bar. If
the screws and rawlplugs provided are not suitable for your specific circumstances, make sure that the dimensions of the screw head and shaft correspond to
those provided in order to guarantee safe mounting.
•
Phillips screwdriver and possibly other screwdrivers, spirit level, pencil
Before drilling, make sure there are no water or gas pipes or electricity cables in the wall. If necessary, get an expert to mount the device on the wall.
•
Drill two holes 740 mm apart. Use the drilling template supplied to make mounting easier.
•
If you are using the rawlplugs supplied, use an 8 mm drill bit.
•
Insert the rawlplugs into the drilled holes.
•
Push the screws in until the screw head projects by about 3 mm.
•
Connect all the cables you are using to the connections on the sound bar.
•
Position the device with the wall mounting holes down onto the screws so that they engage with the vertical holders on the wall mounting system, then secure
by tightening the screws.
•
Finally, check that the sound bar is firmly fitted to both screws. If necessary, repeat the process. It may be necessary to rotate the screws clockwise or
counterclockwise a little.
®
SSB 70 D2
English - 21