Publicité
Les langues disponibles
Les langues disponibles
SSB 70 D2
WARNING! Radio interface
Turn the device off when on board an aircraft, in a hospital, in an operating theatre or in the vicinity of electronic medical equipment. The RF signals may interfere
with the functionality of sensitive devices. Keep the device at least 20 cm away from pacemakers, as the RF signals could interfere with the functionality of the
pacemaker. The RF signals transmitted can interfere with hearing aids. If wireless mode is switched on, do not place the device near flammable gases or in a
potentially explosive area (e.g. a paint shop), as the RF signals transmitted could cause explosions or fire. The range of the radio frequency signals depends on
environmental conditions. If data is transmitted via a wireless connection, it can also be received by unauthorised parties. Targa GmbH is not liable for any
interference caused to RF or TV signals through unauthorised modification to this device. Furthermore, Targa accepts no liability for replacing any cables or devices
that have not been specifically approved by Targa GmbH. The user is solely responsible and liable for remedying any interference caused by such unauthorised
modification of this device or for replacing the device.
Servicing / Repair
Repairs are required when this device has been damaged in any way, for example, when the device housing is damaged, when liquids or objects have entered
the device or when the product has been exposed to rain or moisture. Repairs are also necessary if the product is not working properly or has been dropped. If
you notice any smoke, unusual noise or strange smells, switch off the device immediately and pull the power cable out of the socket. If this occurs, the device should
not be used before it has been inspected by authorised service personnel. All repairs must be carried out by qualified service personnel.
Operating environment
The device is not designed for use in environments with high humidity (e.g. bathrooms) or excessive levels of dust. Operating temperature and operating humidity:
0 °C to 35 °C, max. 85 % relative humidity. Please note that caring products for furniture surfaces may contain substances that can damage the rubber feet of
the sound bar, so be careful if you have been using this type of products.
Note on mains disconnection
Please remember that the power adapter consumes a small amount of electricity when the mains plug is connected to the mains socket, even in standby mode. To
disconnect it completely, unplug the mains plug from the mains socket.
6. Copyright
All the contents of this user manual are protected by copyright and provided to the reader for information only. Copying data and information without the prior
explicit written consent of the author is strictly forbidden. This also applies to any commercial use of the contents and information. All texts and diagrams are up-to-
date as of the date of printing. Subject to change without notice.
7. Connections and controls
An illustration of the items and controls and their corresponding numbers can be found on the inside page of the fold-out cover of this user manual. You can keep
this page folded out whilst reading the different chapters of these operating instructions. This allows you to refer to the relevant controls at any time.
20 - English
1 LED display
2 On/Standby button
3 Source button (signal source selection)
4 USB port (not to be used for charging)
5 + button (increase volume)
6 - button (reduce volume)
7 Device feet
8 Wall-mounting holes
9 Power cable
10 HDMI ARC jack
11 optical digital input (Toslink)
12 3.5mm AUX-IN socket
Publicité
