Télécharger Imprimer la page

SilverCrest SSB 70 D2 Mode D'emploi Et Consignes De Sécurité page 25

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
9. Getting started
This user manual generally describes using the remote control.
Some basic functions (on/standby, source selection and volume setting) can also be adjusted directly from the sound bar.
The soundbar switches to standby if...
...no Bluetooth connection is established within 10 minutes or if no audio signal is received over the existing Bluetooth connection.
... no audio signal or only a weak audio signal is received for 20 minutes and no buttons are pressed.
In HDMI(ARC) and OPTICAL modes, please note:
If your audio source supports multi-channel playback, you need to switch it to "PCM Stereo" before getting started, as the sound bar will
otherwise be unable to output sound. Please refer to the user manual for your audio source.
9.1 Switching on the sound bar
Plug the mains plug of the sound bar into an easily accessible mains socket. The sound bar has no separate main switch, it goes straight into standby mode
immediately it is plugged in. The LED display (1) shows "- -". Press the Standby button
9.2 Switching the sound bar off
Press the Standby button
(36) to switch the sound bar into standby mode. Alternatively, you can press the Standby button
bar has no separate main switch. Please remember that the power adapter consumes a small amount of electricity when the mains plug is connected to the mains
socket, even in standby mode. To disconnect it completely, unplug the mains plug from the mains socket.
9.3 Selecting a mode
Press the relevant button (14, 15, 16, 34, 35) to select the mode you want. Alternatively, you can toggle through the modes by briefly pressing the Source selection
button (3) on the sound bar several times. The mode selected is shown as follows on the LED display (1):
Now start playback on the connected device and control using the remote control. See the user manual for the playback device.
9.3.1 "HDMI ARC" mode
HDMI (ARC Audio Return Channel) is an extension to the conventional HDMI connection which allows ARC channel audio signals to be
transmitted in both directions. In order to use this functionality, all the components used must be ARC-compliant.
Most modern TV sets, games consoles and digital receivers have an ARC output. Please refer to the user manual for the device to be
connected.
If the audio transmission does not work, make sure that the HDMI cable and the connection on the source device are ARC-compliant. It is
possible that only specific connections on the source device are ARC-compliant.
How to connect the sound bar to a TV set is described below:
Using an HDMI(ARC)-compliant cable (C, supplied), connect the HDMI(ARC) jack (10) on the sound bar to an HDMI(ARC) output on the TV set. Set the
connected device to "PCM Stereo" or "Stereo 2.0".
Switch the sound bar on using the standby button
Press the "HDMI (ARC)" button (14) to select the HDMI(ARC) input on the sound bar.
Switch the TV set on, the sound playback will start within a few seconds.
If your TV set supports the CEC protocol, the sound bar can be switched on and off using the TV remote control. If this is the case, the volume
can also be controlled via the TV remote control. See the user manual for the TV set.
Mode
Display
HDMI ARC
Hd
OPTICAL
OPtI
BLUETOOTH
®
bt
USB
USB
AUX
AUX
(2, 36).
(2, 36) to wake the sound bar up from standby mode.
SSB 70 D2
(2) on the sound bar. The sound
English - 23

Publicité

loading

Ce manuel est également adapté pour:

386218 2110