Volume Control - Doro 505 Manuel D'utilisation

Memory
This telephone has 10 indirect memories.
When a number is stored in a memory location, you need to press only two
buttons to make the call. The memories are stored on the keypad digits 0-9.
Storing Memories
1. Press and hold
P
2. Enter a memory location
3. Enter the desired telephone number (up to 22 digits). Use C to erase or
change an entry.
4. Press . The number is now stored.
0
5. Enter another memory location to continue or press C to return to standby
mode.
Memory Dialling
1. Lift the handset (or press the
2. Press .
P
3. Select a memory location by pressing the relevant keypad number,
Press . If you want a pause in the telephone number.
r
In case of a number change, store the new number in the location of the old one following
the procedure above.

Volume Control

The handset volume may be adjusted during a call using the switch located on
the handset.
The hands free speaker volume may be adjusted during a call using the switch
located on the right hand side of the base unit.
Ringer
The Ringer volume can be set to three modes – high, low or off – using the
switch located on the underside of the telephone.
www.doro.com
Operation
until Setup is shown.
- on the telephone keypad.
0 9
button) and wait for a dialling tone.
s
English
- .
0 9
7