Least Cost Routing - Doro 505 Manuel D'utilisation

Using Least Cost Routing (LCR)
This function will automatically select the telephone network operator of choice.
The telephone can be set up to add digits and/or replace certain digits in
telephone numbers.
To choose a certain network operator, you would normally dial a prefix code
before the actual telephone number.
If you have chosen a certain LCR operator for international calls, in order to
dial your calls using their service you must dial a prefix code before the country
code, for example 9502. You can program the LCR function so whenever you
dial a number beginning with 00, the phone will automatically change this to
950200.
For example: 0046462805000 would automatically be dialled
95020046462805000.
Please note!
In order to place your call with a certain operator you must be a registered subscriber.
Only one LCR setting can be active at a time.
Setting Up LCR
1. Press and hold
P
2. Press twice. The display will show
P
3. Scroll to the desired function using
4. Press . The left side of the display will flash.
0
5. Enter the dialling sequence to be replaced (up to four digits, e. g. 00).
Use C to erase or change an entry.
6. If you have entered less than four digits, press
of the display will flash.
7. Enter the new dialling sequence (up to eight digits, e. g. 950200).
If there's already a number entered here, it can be erased using C.
8. Confirm the programmed settings by pressing
www.doro.com

Least Cost Routing

until Setup is shown, and then release.
Lcr
/
v
and (active) or
on oFF
.
V
to move on. The right side
0
.
0
English
(off).
11