Publicité
Les langues disponibles
Les langues disponibles
Incorrect use, mechanical deformation, equipment accidentally dropped from a height, wear,
chemical contamination, exposure to heat above normal climatic conditions (max 100°C for purely
metallic articles and max. 50°C for articles with parts in fabric), are just some examples of other
reasons possibly reducing, limiting and even terminating the service life of the article.
2.3
- Users are responsible for using this article correctly.
2.4
- This article may be used in combination with individual protective devices conforming to the
89/686/EEC Directive, compatibly with relevant instructions for use.
2.5
- The resistance of natural or not natural anchorages in the rocks is not a priori guaranteed, it is
therefore essential that users carefully judge for themselves beforehand to ensure adequate
protection.
2.6
- For safety's sake,
• users shall evaluate all the possible risks and be sure that the whole safety system (anchor
point, attachments, safety line, harness, etc. etc.) of which this equipment is a component, is
reliable and safe, in addition to this, with systems blocking a fall check:
• whenever possible the anchorage point is above the user,
• use a full body harness,
• organise the work with the purpose of reducing to a minimum any potential fall and its
heights.
2.7
- The anchorage position is essential for safely blocking a fall: carefully judge the height of the
fall, length of cord and "pendulum" effect to avoid all possible obstacles (e.g. ground, articles
scraping against the rocks, etc.).
2.8
- Your life depends on the continual efficiency of your equipment (we thoroughly recommend
personal use of equipment) and how it is kept (use, storage, controls, etc.).We strongly recommend
having pre and post-use controls carried out by a qualified person. An accurate overhaul by a
manufacturer's qualified technician at least once a year is also recommended. The user is
responsible for recording and conserving the information given in the "Record" table together with
the instructions.
2.9
- KONG Spa shall not be held liable in any way for damages, injuries or death caused by:
improper use, changes made to product, repairs by non-authorized persons or use of non-original
spare parts.
2.10
- No special precautions should be taken for transportation, do however avoid contact with
chemical reagents or other corrosive substances and protect all the pointed, sharp parts
adequately. Warning: never leave your equipment in cars parked in the sun!
2.11
– Warning: it is compulsory for dealers to have these instructions for use translated for
products sold in countries other than those selected by KONG Spa.
3 - MAINTENANCE AND STORAGE
No particular maintenance has to be done by the user, the article just has to be cleaned and
lubricated, as explained below.
3.1
- Cleaning: frequently rinse the product under lukewarm fresh water (max. 40°C), eventually
adding a delicate detergent (neutral soap). Leave it to dry naturally away from direct sources of
heat.
3.2
- Lubrication: frequently lubricate the moving parts with silicone based oil. Avoid contact
between oil and fabric parts. This operation must be done after cleaning and thoroughly drying.
2
Publicité
