Publicité
Les langues disponibles
Les langues disponibles
HOW TO ASSEMBLY THE BOTTOM PROTECTION:
The assembling of the two sheets shall be made with the stretcher empty.
Overturn the stretcher and place sheet n°1 (feet side) (fig. 48). Push it towards the feet head
o
until the two blocks ("L" shaped) engage the spacing bars (fig. 49);
Lay it on the central spacing bar and pull it back towards the stretcher centre to engage the
o
central "L" shaped blocks (fig. 50 e 51)
Lay sheet n°2 (head side) - it shall be overlapping sheet n°1- push it towards the centre to
o
engage the blocks on the central spacing bar (fig. 52); pull it back until the two blocks
engage the external spacing bar (fig. 53);
Now the four "U" shaped blocks of the two sheets shall be in correspondence to the vertical
o
lateral bars of the heads;
Insert the two long "U" bars on to the blocks (fig. 54 e 55);
o
Secure the "U" long bars inserting the split pins supplied (fig. 56).
o
7.6 HAND SHAFTS (# 871.50 – kit of 2 pairs)
Hand shafts allow two rescuer to drive Kong Stretcher when fitted with a single and/or double wheel
(fig. 57).
This shafts can be used also for shoulder transport by four people.
7.7 SINGLE WHEEL (# 871.20) AND DOUBLE WHEEL (# 871.22)
Designed to make easier the injured transport on flat and not rough route. (fig. 58 e 59).
HOW TO ASSEMBLY WHEEL(S)
Insert the hand shafts (# 871.50) into the heads (procedure is the same as shoulder shafts);
o
Lift the stretcher carrying it close to the head (fig. 60) and insert the profiles under the
o
longitudinal bars;
N.B. it might be necessary to slightly enlarge or to narrow the two longitudinal bars
It is possible to fix the wheel(s) in any position to find the correct barycentre (it is normally
o
located where shown in fig. 61);
Screw or unscrew the threated hook to find the better snap position (fig. 62);
o
The high of the wheel(s) can be varied from mm 460 up to mm 570 unblocking the spring
o
pins on the fork sides (fig. 63);
WARNING!
A stretcher fitted with one wheel shall be driven and controlled by two rescuers.
o
It is also possible a combined installation of a double wheel (preferably on the back side) and of
one single wheel (preferably front side).
N.B. to make a bent, it is necessary to lift the single wheel
7.8 HOW TO USE HANGING KIT "ORION" (# 871.00):
Hanging kit Orion has been studied to lower or lift Kong Stretcher by winches, fishing poles,
tripods, helicopters, etc...
• Fix hanging kit to stretcher by inserting the four screw sleeves connectors stitched on the four
arms; insert the connectors from outside towards inside first onto the head and then into the
webbing loop stitched on the cloth bag (fig.64). Follow reference colours (red: head side -
9
Publicité
