Publicité
Les langues disponibles
Les langues disponibles
CHARGING BATTERY PACK
Plug charger cord into your standard power outlet.
With no battery pack inserted, the charger's green indicator light
will go ON. This indicates the charger is receiving power and the
charger is ready for operation.
When you insert the battery pack (1) into the charger
(2). The charger's green indicator light (4) will begin
to "BLINK". This indicates that the battery is receiving
a fast charge.
Once approximately 80% battery capacity has been reached, the
blinking of green light will slow down, indicating that fast charging
is now complete. If battery remains in charger, the charging
process is completed in Long Life charging mode.
The purpose of the rapidly "BLINKING" green light is to indicate that the battery pack is fast-charging.
It does not indicate the exact point of full charge. The light will stop blinking when battery is fully
charged.
Continuous green battery charger light (4) indicates that the battery is fully charged.
However, the battery pack may be used at any time, even if the green light is still blinking.
A steady red indicator light (3) means that the battery pack is outside the proper
temperature ranges (too hot or too cold) so the charger will not begin the charging
process. Charging (Fast or long Life Charging Mode) is only possible when the temperature
range of the battery pack is between 32°F (0°C) and 113°F (45°C).
As soon as the battery pack reaches the correct temperature range, the battery charger will
automatically switch to fast charging.
If the red indicator light (3) is "BLINKING", the battery pack cannot accept a charge. This
may be due to the contacts on the charger or battery pack is contaminated, the battery
pack itself may be defective, or battery may be wrong type for this charger.
• Confirm battery compatibility with charger by checking Battery/Charger List.
• If applicable, insert another compatible battery pack into charger to verify charger is working
properly.
• Clean the contacts of the charger or battery pack (e. g. by using a cotton swab and rubbing alcohol
on battery and charger terminals or inserting and removing the battery several times) or replace the
battery pack, as required.
When the battery pack is fully charged, unplug the charger (unless you're charging another battery
pack) and slip the battery pack back into the tool.
1
2
4
3
9
EN
Publicité
