Publicité
Les langues disponibles
Les langues disponibles
VARIABLE TEMPERATURE SETTINGS
The temperature of the heat tool ranges from 500˚F on its lowest
setting to 1000˚F on its highest setting. See the chart on the next
page to determine the appropriate temperature for the project you
are doing.
Press the (+) button to increase the temperature setting. Press the (-)
button to decrease the temperature setting. The lights will light up
sequentially (left to right) and indicate the current temperature setting
of the heat tool.
When starting up a new task, the heat tool will "remember" the last temperature setting being used
when it was shut down the last time.
STARTUP
Smoke may appear during the initial start up due to the burning of manufacturing
oils. The smoke should disappear in less than a minute.
Heat tool use is safe if all safety guidelines are used, but always keep either a
container of water or an ABC fire extinguisher (suitable against Class A, B and C type
fires) within reach.
1. Make sure the battery is charged and install it into the bottom of the heat tool (refer to page 9).
2. Press the variable temperature buttons ( + or - ) to the desired setting, push the lock OFF button and
pull the trigger. The motor driven fan noise will indicate that the unit is running.
If the blower motor in the heat gun does not turn on when the trigger is pulled
immediately let go of the trigger. The heating element will burn out if it is not cooled
by the blower.
Attention
3. To use in hands-free position, tilt the heat tool on its back and activate the Lock ON button.
4. When done using the tool, or in between projects, release the trigger and follow the Cool Down
procedure, below).
HANDS FREE OPERATION / COOL DOWN PROCEDURE
1. Carefully set the gun backwards on the bumpers. DO NOT
touch the nozzle.
2. For hands-free operation, pull the trigger and lock the trigger
into place by pressing the lock ON button (A).
3. For cool down mode, press the lock OFF button (B). Allow
the nozzle 20 minutes to cool.
Always use gloves when handling the
heat tool.
Keep the nozzle pointed up after
shutdown until it fully cools.
12
EN
LOW
A
B
HIGH
Publicité
