Publicité
Les langues disponibles
Les langues disponibles
SHRINK TUBING
Slide heat shrink tubing onto the wire so that it covers the damaged/exposed section.
Select either the low or high temperature setting based on heat shrink tubing's recommended
temperature.
Keep the heat gun moving back and forth along the length of tubing and rotate the wire for even heat
distribution.
If covering a long length of wire with tubing, begin shrinking at one end, and gradually work your way
to the other end.
When the shrink tube is uniformly tightened immediately stop applying heat. Do not overheat the heat
shrink tubing. Allow the tubing to cool slowly before applying physical stress to it.
SHRINK WRAPPING
Wrap the object with heat-shrinkable plastic film. Begin to heat the film from a safe distance while
keeping the heat tool moving. Move the heat tool closer to the film until the film starts to shrink and
tightens around the object.
CLEANING AND MAINTENANCE
Make sure the trigger has been locked OFF, the battery is removed, and the heat tool
has sufficiently cooled before cleaning.
Keep the intake openings on the housing clean and free of obstructions. Us a soft, dry brush to clean
the openings periodically. Use only mild soap and a damp cloth to clean the heat gun. Many household
cleaners contain chemicals which could seriously damage the housing.
Do not use gasoline, turpentine, lacquer or paint thinner, dry cleaning fluids or similar products when
cleaning the heat gun. Never allow any liquid to get inside the tool or immerse any part of the tool into
a liquid.
15
EN
Publicité
