Publicité
Les langues disponibles
Les langues disponibles
Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
•
Remove the battery before you do maintenance,
other checks or assemble the product.
•
The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
•
Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
•
If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
Introduction
This section describes how to assemble and adjust the
product.
WARNING:
product, read the safety chapter and the
assembly instructions.
To install the handle
•
Install the handle with the 2 screws.
To adjust the harness
Always use the harness when you operate the product.
The harness gives maximum control during operation of
Introduction
WARNING:
product, you must read and understand the
safety chapter.
2130 - 003 - 02.07.2024
Read the warning
Assembly
Before you assemble the
Operation
Before you operate the
•
Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
•
Keep the teeth of the blade correctly sharpened.
Obey our recommendations. Also refer to the
instructions on the blade package.
•
Only use original spare parts.
•
Always use heavy duty gloves when you repair the
cutting attachment. The blades are very sharp and
can easily cause injuries.
the product. The harness decreases the risk of tiredness
in your body.
1. Put on the harness.
2. Attach the product to the harness support hook.
3. Adjust the length of the harness until the support
hook is level with your hip.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
11
Publicité
