Publicité
Les langues disponibles
Les langues disponibles
2. Remove the battery.
3. Check that the hand guard is attached correctly.
4. Examine the hand guard for damages.
To do a check of the blades
1. Stop the product.
2. Remove the battery.
3. Put on protective gloves.
4. Make sure that the blades are not damaged or bent.
Replace the blades if they are damaged or bent.
Battery safety
WARNING:
instructions that follow before you use the
product.
•
Only use the BLi200 or 40-B220X battery. Refer
Approved batteries on page 20 . The battery is
to
software encrypted.
•
Use the BLi200 or 40-B220X battery that is
rechargable as a power supply for the related
Husqvarna products only. To prevent injury, do not
use the battery as a power supply for other devices.
•
Risk of electrical shock. Do not connect the battery
terminals to keys, coins, screws or other metal. This
can cause a short circuit of the battery.
•
Do not use non-rechargeable batteries.
•
Do not put objects into the air slots of the battery.
•
Keep the battery away from sunlight, heat or open
flame. The battery can cause burns and/or chemical
burns.
•
Keep the battery away from rain and wet conditions.
•
Keep the battery away from microwaves and high
pressure.
•
Do not try to disassemble or break the battery.
•
If the battery leaks, do not let the liquid touch your
body or eyes. If you have touched the liquid, clean
the area with a large quantity of water and soap, and
get medical aid. If you get liquid in your eyes, do not
rub but flush with water for a minimum of 15 minutes
and get medical aid.
•
Use the battery in temperatures between -10 °C (14
°F) and 40 °C (114 °F).
•
Do not clean the battery or the battery charger with
To clean the product, the battery and
water. Refer to
the battery charger on page 16 .
•
Do not use a defective or damaged battery.
•
Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
•
Keep the battery away from children.
10
Read the warning
Battery charger safety
WARNING:
instructions that follow before you use the
product.
•
Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
•
Use approved grounded mains socket that are not
damaged.
•
Do not use other battery chargers than the one
supplied for your product. Only use Husqvarna QC
chargers when you charge Husqvarna replacement
batteries BLi.
•
Do not try to disassemble the battery charger.
•
Do not use a defective or damaged battery charger.
•
Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
•
Keep all cables and extension wires away from
water, oil and sharp edges. Make sure that the
cable is not caught between doors, fences or similar
objects.
•
Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that there are no covers on the battery
charger. Pull out the plug to the battery charger if
there is smoke or fire.
•
Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
the battery outdoors. Do not charge the battery in
wet conditions.
•
Only use the battery charger where the temperature
is between 5 °C (41 °F) and 40 °C (104 °F). Use the
charger in an environment which has a good airflow,
dry and free from dirt.
•
Do not put objects into the cooling slots of the
battery charger.
•
Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
•
Only use three-wire outdoor extension wires that
have three-prong grounding plugs and grounding
receptacles that accept the appliance's plug.
•
Use a residual-current device (RCD) for increased
safety. A residual-current device is installed to
prevent injuries from an electrical fault.
•
When you operate a power tool outdoors, use an
extension wire applicable for outdoor operation. Use
of a wire applicable for outdoor operation decreases
the risk of electrical shock.
•
Regularly make sure that the connection cord of the
battery charger is not damaged and that there are no
cracks in it.
•
Examine extension wires regularly and replace them
if damaged.
Read the warning
2130 - 003 - 02.07.2024
Publicité
