LIVARNO home HG03864A Manuel D'installation Et De Sécurité page 10

2. Firmly grip the upper pole and
the tilt joint cover with one
hand, and grip the upper pole
below the tilt joint with the
other, then tilt the canopy
towards the side (Fig. D).
˜ Righting the canopy
m CAUTION! RISK OF
INJURY!
Keep yout fingers away from
the tilt joint when using the tilt
joint cover to avoid pinching
your fingers.
1. Firmly grip the upper pole
and the tilt joint cover
6 ] [
and pull the canopy
upright position.
2. Slide the tilt joint cover down
to cover the tilt joint
secure the canopy in position.
˜ Closing the product
1. Make sure the product is fully
upright (see chapter "Righting
the canopy").
2. Press down on the catch spring
whilst firmly holding on to
3 ] [
the slider
4 ] [
3. Slowly pull down on the slider
to close the canopy
A).
1 ] [
5 ] [
to the
[ 1 ]
and to
5 ] [
(Fig. A).
(Fig.
1 ] [
4. Securely fasten the canopy
using a strong cord and tie it
around the canopy (Fig. E).
˜ Carrying the product
1. Close the canopy
remove the upper pole
from the bottom pole
reversing the steps in chapter
"Assembling the product".
2. Put the product into the carry
bag and secure the bag's
[ 9 ]
opening with the bag tie (Fig.
A).
˜ Storage
NOTICE! RISK OF DAMAGE!
When not in use, always keep
the product closed to avoid
damage to the product or to
property.
1. Close the product and securely
fasten a strong cord around the
canopy .
[ 1 ]
2. Store the product securely on
its base or in its carry bag
10 ] [
.
[ 9 ]
If stored in the carry bag, place
o
the product in a secure and dry
location.
and
1 ] [
6 ] [
by
8 ] [
GB/IE/NI 9