Hach 9501000 Instructions D'utilisation page 13

Configuration
Configure the sampler
1. At the sampler controller, configure the AUX I/O port. Refer to the sampler operations
documentation.
2. Select Programming>Sample Programming>Pacing.
3. Select Fixed Flow (or Variable Flow) as applicable. Refer to the sampler operations
documentation.
4. Select Flow Source>AUX-mA (or AUX-Pulse).
Maintenance
Multiple hazards. Only qualified personnel must conduct the tasks described in this section of the
document.
Replace a fuse
Electrocution hazard. Remove power from the instrument before this procedure is started.
Fire hazard. Use the same type and current rating to replace fuses.
A blown fuse can be an indication that the instrument has a problem and service is necessary. Refer
to Specifications on page 3 for the fuse rating. Refer to the illustrated steps that follow to replace a
fuse.
Replacement parts and accessories
Personal injury hazard. Use of non-approved parts may cause personal injury, damage to the
instrument or equipment malfunction. The replacement parts in this section are approved by the
manufacturer.
Note: Product and Article numbers may vary for some selling regions. Contact the appropriate distributor or refer to
the company website for contact information.
C A U T I O N
D A N G E R
D A N G E R
W A R N I N G
English 13