MELINERA HG03854A Instructions D'utilisation Et Consignes De Sécurité page 10

Preparing for use
Note: Remove all packaging materials from the product.
Installing the product
Install the product in accordance with Figures A, C, D:
1. Rotate the solar cell housing
lamp shade
2. Move the ON / OFF switch
switch the light on.
3. Insert the solar cell housing
tighten by turning it clockwise.
4. Place the lamp shade
5. Take out the ground stake
the ground stake
downwards (see Fig. C).
6. Your product is ready for use (see Fig. D).
Setting up the product
Insert the assembled product far enough into the ground
(lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance at all
times. Do not use any force when assembling or setting-up
the product, e.g. hammer blows. This will damage the
product. In order to achieve the best result, set the product
up in a place where the solar cell will get direct sunlight
for as long as possible.
Make sure that the solar cell is not influenced by any
other source of light such as yard or street lighting as
otherwise the light will not come on in twilight.
The light automatically switches on in twilight conditions and
off again when normal outdoor lighting conditions return.
Replacing the rechargeable battery
The rechargeable battery should be replaced every
12 months to ensure optimum performance.
1. Separate the solar cell housing
by moving it anti-clockwise (see Fig. A). Switch off the
2
light with the ON- / OFF-switch
2. Loosen the fastening screws
head screwdriver and then lever out the battery compart-
ment lid
slot screwdriver (see Fig. B).
10 GB/IE/NI
(see Fig. A).
2
2
into the pole
4
of the solar cell housing
7
anticlockwise out of the
1
into the ON position to
5
into the lamp shade
1
on to the pole
from the pole
4
with the tip facing
3
from the lamp shade
1
.
5
by using a small cross
6
with the help of a
1
and
2
.
3
and insert
3