Husqvarna 520iLX Manuel D'utilisation page 8

3. The grass is cut down with a sideways, swinging
movement, where the movement from right-to-left
is the clearing stoke and the movement from left-to-
right is the return stoke. Let the left-hand side of the
blade (between 8 and 12 o'clock) do the cutting.
4. If the blade is angled to the left when clearing grass,
the grass will collect in a line, which makes it easier
to collect, e.g. by raking.
5. Try to work rhythmically. Stand firmly with your feet
apart. Move forward after the return stoke and stand
firmly again.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
Refer to the operator's manual of the end product for
maintenance schedule.
To sharpen the grass knife and grass
blade
WARNING:
protective gloves.
Transportation and storage
Use the transportation guard on the product to prevent
injuries or damage to the product during transportation
and storage.
Technical data
Approved accessories
Output shaft thread M10
Center hole in blades/cutters, Ø 25.4 mm
Terms
Grass blade/grass cutter
Trimmer head
Support cup
8
Maintenance
Before you do any
Stop the motor. Use
Transportation, storage and disposal
Technical data
Type
Grass blade 255-4 (Ø 255 4 teeth)
T25B (Ø 2.0 mm - Ø 2.4 mm Whisper line
Fixed
6. Let the support cup rest lightly against the ground. It
is used to protect the blade from hitting the ground.
7. Reduce the risk of material wrapping around the
blade by always work at full speed and avoid the
previously cut material during the return stoke.
8. Stop the motor, unclip the harness and place the
machine on the ground before you start to collect the
cut material.
• To sharpen the grass knife or grass blade correctly,
refer to the instructions that come with the cutting
attachment.
• Sharpen all edges equally to keep the balance.
• Use a single-cut flat file.
WARNING:
that is damaged. Do not try to make a bent
or twisted blade straight and use it again.
For more information, refer to the operator's manual of
the end product.
Cutting attachment guard
577 01 83-05
577 01 83-05
–
Always discard a blade
2360 - 001 - 03.06.2024