Husqvarna 520iLX Manuel D'utilisation page 3

5. Single harness
6. Socket wrench
7. Drive disc
8. Grass blade
9. Support cup
10. Support flange
11. Locknut
12. Operator's manual
Product damage
We are not responsible for damages to our product if:
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
damage to the product, other materials or
the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.
General safety instructions
WARNING:
instructions that follow before you use the
attachment.
• Please read the operator's manual carefully and
make sure you understand the instructions before
using the attachment.
• These instructions supplement the instructions
that were included with the product. For other
procedures, please refer to the operating instructions
for the product.
• Under no circumstances may the design of the
attachment be modified without the permission of
the manufacturer. Do not use an attachment that
appears to have been modified by others and
always use original accessories. Non-authorized
modifications and/or accessories can result in
serious personal injury or the death of the operator
or others.
2360 - 001 - 03.06.2024
Used if there is a risk of
Used if there is a risk of
Read the safety
• the product is incorrectly repaired.
• the product is repaired with parts that are not
from the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is not repaired at an approved service
center or by an approved authority.
Safety
Safety instructions for assembly
Assembly of trimmer heads
WARNING:
cutting attachment it is very important that
the raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If the cutting
attachment is install incorrectly it can result
in serious and/or fatal personal injury.
WARNING:
attachment without an approved guard. See
the chapter on Technical data. If an incorrect
or faulty guard, or the J-handle is missing
when using metallic cutting attachment, is
fitted this can cause serious personal injury.
Blade thrust causes and related
warnings
Blade thrust is a sudden sideways, forward or backward
motion of the machine, which may occur when the blade
jams or catches on an object such as a sapling or a tree
stump. It can be violent enough to cause the machine
and/or operator to be propelled in any direction, and
possibly loose control of the machine. Blade thrust and
its related hazards can be avoided by taking proper
precautions as given below.
• Maintain a firm grip with both hands on the machine
and position your arms to resist blade thrust.
Position your body to the left side of the machine.
Blade thrust can increase the risk of injury due to the
machine moving unexpectedly. Blade thrust can be
controlled by the operator if proper precautions are
taken.
• If the blade binds, or when interrupting a cut for
any reason, switch the machine off and hold the
machine motionless in the material until the blade
comes to a complete stop. While the blade is
binding, never attempt to remove the machine from
the material or pull the machine backward while the
When you install the
Never use a cutting
3