Husqvarna 520iLX Manuel D'utilisation page 5

• Always stop the product, remove the battery and
make sure that the cutting equipment does not rotate
before you remove material that is wound around the
To assemble the J-handle
WARNING:
grass blades/grass cutters or trimmer heads/
plastic blades. Do not use saw blades or
clearing blades with the J-handle.
1. Attach the J-handle to the loop handle with 3 screws.
2. Adjust the product to an applicable work position.
3. Tighten the screws.
To install the suspension ring
1. Install the suspension ring to the shaft between the
rear handle and the loop handle.
2. Adjust the ring and the single harness to make the
product balanced and easy to use.
2360 - 001 - 03.06.2024
Assembly
Use the J-handle with
blade shaft or caught between the guard and the
cutting attachment.
3. Attach the single harness to the suspension ring.
Use the single harness when you operate the
product.
4. Make sure that the single harness is easy to remove
from the shoulder.
To attach the grass blade
1. Put the gear of the product on a flat surface to make
sure that the blade is assembled correctly.
2. Turn the output shaft to align one of the holes in
the drive disc (B) with the related hole in the gear
housing.
3. Put the locking pin (C) in the hole to lock the shaft.
4. Put the grass blade (D), the support cup (E) and the
support flange (F) on the output shaft.
G
B
C
5. Make sure that the drive disc and support flange
engages correctly in the center hole of the grass
blade.
6. Attach the locknut (G).
F
E
D
A
5