Berker 7574 01 01 Mode D'emploi Et Instructions De Montage page 39

(12)
(11)
5.2 Commissioning
system link – Loading the physical address and application software
The device is connected to the KNX bus and auxiliary voltage.
P
The physical address is only ever assigned for one device. Only one de-
vice can ever be in programming mode.
Switch on bus voltage
„
Switch on auxiliary voltage.
„
Press programming button
„
The programming LED
Or via the menu:
Press control surface
„
07:22
The display changes to the menu
Then select
„
Switch control surface for
„
The device is in programming mode.
Load the physical address into the device.
„
The programming LED goes out. In the display, the message
automatically.
Seite 6 Seite 7
Load application software into the device.
„
Stick enclosed stickers on the back of the device and note down the phys-
„
ical address.
Figure 12: Dismantling
(5) at the back of the device.
(5) lights up.
in the top display row (8).
- -
–
appears briefly. The device is restarted
.
in succession.
.
ON
z
39