Berker 7574 01 01 Mode D'emploi Et Instructions De Montage page 37

If the device should also be used for temperature control, lay an external
temperature sensor (see Accessories) in a ductwork and guide out the sensor
head at the measurement point.
P
Do not install the temperature sensor near any sources of interference,
e.g. electric stoves, refrigerators, draughts or sunshine. These influence
the temperature measurement of the sensor.
Plug the enclosed pre-assembled cable into the jack
„
Connect the external temperature sensor to the conductor sleeves of an
„
input of this cable:
- Input 1: black GND/white
- Input 2: black GND/yellow
- Input 3: black GND/purple
- Input 4: black GND/blue
P
All black connecting wires GND are connected together internally.
Attach the design frame (11) at the back and press over the fixtures (15)
„
until it snaps into place.
Position the device over the supporting ring in the correct position so that
„
the mounting devices on the device (13) and the pins on the supporting
ring (12) are lying on top of each other (Figure 10).
Slowly press the device onto the support ring (12) until the clamping
„
springs (16) engage in the support ring and the magnetic holding points
(14) additionally secure the support ring.
(12)
(11)
Figure 10: Installation
z
(4).
37