Signature SHD60PERI/3 Manuel D'utilisation page 32

Note: Remember not to fix the screws
(4mm x 8mm) too tight. 1mm loose is
recommended so that later height
adjustment can be done easily.
7. Fix the hood on the wall. Also, fix the
cooker hood on the wall by two 4 x 30mm
screws and wall plugs througt the back of
the cooker hood. See pic.6.
8. Apply the chimney on the cooker hood
body, fix the "plate I" on the lower two
holes of the wall using 2 screws
(4mm*40mm). Tighten the two sides of the
chimney to the hood with 2 screws
(4mm*8mm). Fix the "Plate I" onto the other
two holes of the wall using 2 screws.
(4mm*40mm). See pic.7.
9. Pull up the inner chimney, and secure the
inner chimney onto the "Plate I" using 2
screws (4mm*8mm). See pic.8.
- 31 -