Publicité
Les langues disponibles
Les langues disponibles
About the dishwasher control panel.
D
Enhancements
The light above the selected pad will be ON to indicate which ENHANCEMENThas been selected.
DELAY HOURS
You can delay the start of a wash cycle for up to 24 hours (depending on model).
Pressthe DELAVSTART pad to choose the number of hours you want to delay the start
of the cycle; then press START/RESET.
Front-Control Dishwashers: The machine will count down and start automatically
at the correct time.
TEMP BOOST/
ADDED HEAT/
EXTRA HOT WASH
STEAM
(on some models)
HEATED DRY
LOCK
RESET
ir.l
Top-Control Dishwashers: After closing the door,the machine will count down
and automatically start at the correct time.
NOTE:To cancel the DELAVSTART selection before the cycle begins, repeatedly press
the DELAVSTART pad until the display is blank.
When selected, the cycle will run longer with heating element on to improve both wash
and dry performance.
NOTE:Cannot be selected with RINSEANDHOLD cycle.
For use with heavily soiled and/or dried-on, baked-on soils.This option IvlUST be
selected PRIORto starting the cycle. The STEAMoption adds 26 minutes to the
cycle time.
NOTE:Cannot be selected with RINSEANDHOLD cycle.
When HEATEDDRY is off, dishes will air dry. Top-control models have a fan that assists
the drying process. The fan will run up to 4 hours affer the CLEAN light illuminates. If
desired, pressing any keypad will turn off the fan.
Light Off: Shuts off the drying heat option. Disheswill air dry naturally (front-control
dishwashers) or fan dry (top-control dishwashers) to save energy.
Light On: Turns the heater on for faster drying. This will extend the total cycle time
between 8 and 58 minutes depending on the cycle selected. On top-control models,
a fan will continue to run up to 2 hours after the CLEAN light illuminates to assist the
drying process. If desired, pressing any keypad will turn off the fan.
NOTE:Cannot be selected with RINSEAND HOLD cycle.
You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you have started a cycle.
Children cannot accidentally start dishwasher bg touching pads with this option
selected.
To unlock the dishwasher controls, press and hold the HEATEDDRY pad for 3 seconds.
The light above the lock pad will turn off. To lock the dishwasher, press and hold the
HEATEDDRY pad for 3 seconds.The light above the LOCI( pad will turn on.
To change a cycle offer washing starts...
Front-Control Dishwashers: Touch the START/RESET pad to cancel the cycle.
TheSTART/RESETlight will flash while the water is pumped out if needed.This tokes
approximately 2 minutes.
Top-Control Dishwashers: Open the door slowly to prevent splash-out.
Touch the START/RESET p ad to cancel the cycle. If the START/RESET l ight is flashing,
close the door until the water pumps out (this tokes approximately 2 minutes)
and the light stops flashing.
When the light stops flashing, the dishwasher can be reprogrammed and restarted.
Start
Front-Control
Dishwashers
Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the
START/RESET p ad one time to begin the cycle. Water fill begins immediately, and approximately
60 seconds later the wash action begins.
When the dishwasher door is fully closed and latched, the control panel lights will display the last settings
you selected. If you don't want to change any of the settings, simply touch the START/RESET p ad to
begin the cycle.
If the door is closed,the indicator lights will turn off if the START/RESET p ad is not selectedwithin 5 minutes.
To activate the display, open and close the door or press any pad.
Publicité
