Télécharger Imprimer la page

GE PDWT300R10WW Manuel Du Propriétaire page 10

Masquer les pouces Voir aussi pour PDWT300R10WW:

Publicité

Les langues disponibles

Les langues disponibles

6EAppliances.com
E"j|
Start
(continued)
D
Top-Control Dishwashers
After selecting the cgcle and desired enhancements, touch the START/RESET p od to reodg the
dishwasher to begin the cgcle. Closethe door to start the cgcle or begin the DELAVSTART countdown.
When the cgcle starts, the water fill begins and opproximotelg 60 seconds later the wash action begins.
The dishwasher will olwogs displog gour lost selection and enhancements. If gou don't wont to change
the settings, simplg touch the START/RESET p od to reodg the dishwasher and close the door to begin
the cgcle.
ALL MODELS:If o power failure occurs NORMALand HEATEDDRYwill outomoticollg be programmed.
Make ong new selections and touch the START/RESET p od to begin the new cgcle.
When the door is opened, the indicator lights will turn off if the START/RESETpod is not selected within
5 minutes. To activate the displog, open and close the door or touch ong pod.
Clean
Front-Control
Dishwasher
The CLEANlight will illuminate and o double beep will sound when o wash cgcle is complete. On some
models, the CLEAN light will turn off when the door is opened. On other models,the CLEANlight will
remain on until the door is opened and then relotched or until ong kegpod is pressed while the door
is latched shut.
Top-Control Dishwasher
The CLEANlight will illuminate and a double beep will sound when a wash cgcle is complete. The CLEAN
light will remain on until the door is opened and then relatched or until any keg is pressed.
ALL MODELS: T o turn off the audible end-of-cycle signal (or re-activate it if it was previously turned off),
press the HEATEDDRYpad 5 times within 5 seconds. A triple beep will sound to indicate the end-of-cycle
beep option has been toggled.
Flashing display lights.
Status Indicator
Lights
START/RESET
What It Means
Cycle has been interrupted by pressing the START/RESET p ad, or there
has been a power failure. Light will stop flashing after the dishwasher
automatically drains out the water. The dishwasher will restart with NORMAL
and HEATEDDRY if the interruption was the result of a power failure.
Recommended dishwasher products.
GErecommends the following products for use in its
dishwashers:
• Foryour manual detergent dispenser,Cascade®
powder, liquid or gel automatic dishwasher
detergents are approved.
• Forgour SmartDispense
TM
Detergent Dispenser,use
onlg the recommended liquid automatic detergents
listed on page 12 of this manual.
• Cascade Crystal Clear ®rinse agents to remove
spots and prevent new film buildup on gour dishes,
glasses,flatware, cookware and plastic. Using rinse
agent also improves drg performance.
• Cerama Bryte ®StainlessSteelAppliance Cleaner
to clean the exterior stainless steel panel of GEand
Profile
TM
dishwashers (for stainless steel exterior
models onlg).

Publicité

loading