GE PDWT300R10WW Manuel Du Propriétaire page 7

About the dishwasher control panel.
You can locate b Jour model number onthetubwall j ustinside thedoor. Throughout thismanual, features andappearance mabl va¢ fromyourmodel.
Front-Control Dishwashers H _ D
[] [] [] [] []
SENSINGWASHING OrvtnG SANmZ_O cLeAN
RINSE C HIINA I WASH PROGRAMS
m
E......_Smart Dispense
LOW DETERGENT
ENHANCEMENTS _ J
I ODED STEAH DRY For_s_co_s
Top-Control Dishwashers
TIME REMAINING
lri ir.i it,!
lri
ENHANCEMENTS _ STATUS
I i []
Smart
Dispense
__ "--'-lJJJ J---1 .r--_7 "''-Jr=_oLocK _LOWDETERGENTIDRYING
ADDED HEATED CONTROLS
l D-F_-,_V II AE ED I) STEAM II lie 'ED _L_prEs s IISENSING IIISANITIZED
El El
Control Settings
_
StatusIndicator Lights
(Indicatorsvar_jb_jmodels)
TheStatus displagtells gou what is happening while the dishwasher is in operation and may flash,
indicating a malfunction.The lights will come ON indicating the sequence of the dishwasher operation.
LOW DETERGENT
SENSING
WASHING
DRYING
SANITIZED
CLEAN
Displagedwhen the SmartDispense
TM
needs to be refilledwith liquid or gel automatic
dishwasher detergent.
NOTE:If gou are not usingSmartDispense
TM
and gou want to turn the LOW DETERGENT
LEDlight off, pressthe ADDED HEATpad 5 times within 3 seconds.You will hear 3
beeps;then the light will go off.You can turn the light back on bg pressing the ADDED
HEATpad 5 times within 3 seconds.
Displagedwhile the Clean Sensor
T M
is measuring the amount of soiland temperature
of water.The dishwasher will adjust the selectedcgcle to achieve optimal performance.
Displagedduring prewash,main wash and rinse periods.
Displagedduring HEATED DRY.
Displagedwhen cgcle has met sanitization conditions.
Displagedwhen a wash cgcle is complete.
_/_ Time Remaining Displag (onsomemodels)
El
During operation, the displag shows the minutes remaining until the cgcle is complete. The displag mag
adjust the remaining time while the Sensinglight is on.The time displayed at the start of each cgcle may
change from the factorg setting as the unit customizes itselfto home use. During a delag start, the displag
will show hours of time remaining until the cgcle starts.
NOTE:This dishwasher is equipped with CleanSensor
TM
with automatic temperature control; therefore,
cgcle length and time mag varg depending on soil and water temperature conditions.
Wash Programs (Selections)
Front-ControlDishwashers:Closeand latch door.Pressthe pod for the desiredwash cblcle.
Top-ControlDishwashers:Usethe arrow pads A v to scroll through the wash cbldeswhile door is open.
NOTE:All cgcle times and water usage information contained in the following section are approximate
values.Actual results will depend on several factors, including but not limited to inlet temperature
and amount of soil in the wash water.
The light above or next to the selected pad will be ON to indicate which WASHCYCLE has been selected.