S+S Regeltechnik SHD Notice D'utilisation page 21

LCD-SHD
®
PREMASGARD
Display-Modul für Drucktransmitter
SHD / SHD-SD / SHD 692
konfigurierbar, dreh- und kippbar
für 0-10 V zu ModBus
Boot display
Operating display
The content and text alignment can be set individually via the menu. In addition to the calculated value and the
set unit, min/max values or the value of the adjacent signal input can also be displayed.
This mode takes you to
values.
Configuration
Setup Buttons
As soon as the LCD-SHD display module is powered, the side
for about 10 seconds. After that, it is switched to the operating display.
>SET<
to the main menu ( main -
Below the display are three control buttons.
4. Open the lid by turning the four bayonet screws in the lid
counterclockwise by about 1/4 turn with a suitable screwdriver. The
screws then spring visibly further. The housing cover can then be
easily removed.
5. When reattaching the lid, please make sure that the lid and seal
are properly seated to further ensure the degree of protection. First
press the bayonet screws into the housing cover and turn the screws
clockwise by about 1/4 turn. Over-tightening is not possible. The
screws should now sit deeper in the screw hole.
6. The assignment of the keys is labeled
the board . In addition, active buttons are shown on the display.
>DOWN<
p. 23) and with
21
display
(p. 23)
to delete the min/max
<DOWN> <SET> <UP
, , > on