S+S Regeltechnik SHD Notice D'utilisation page 19

LCD-SHD
®
PREMASGARD
Module d'affichage pour les transmetteurs de pression
SHD / SHD-SD / SHD 692
configurable, orientable et inclinable
pour 0-10 V vers ModBus
The LCD-SHD display module was specially designed for our PREMASGARD SHD/SHD SD /SH 692
pressure transmitters to allow the measured value to be read directly at the measuring point. The display
module is a configurable display device for pressure transmitters with a standard 0-10 V signal and DIN EN
175301-803-A type connector. The 0-10 V input signal is converted and is available for the ModBus protocol
via RS485.
The display module can be mechanically rotated and tilted, and the display content can be rotated in 90°
steps via the menu. A backlight can also be switched on. In addition to the display of the currently calculated
pressure, the voltage measured at the pressure transmitter or the lowest or highest measured pressure
value (min/max) of the last 24 hours can also be displayed.
The settings for scaling, unit (bar, kPa, psi, inWC, atm, mWC), min/max values, number of values for
averaging, display mode, alignment, backlighting, contrast and ModBus parameterisation are made
conveniently via micro buttons inside the housing and are protected against unauthorised access.
TECHNICAL DETAILS
Voltage supply:
Power consumption:
Input:
Output:
Electrical connection:
Response time:
Accuracy:
Temperature dependence:
Housing:
Display:
Visual display unit:
Ambient temperature:
Protection class:
Protection type:
Standards:
Compatibility:
Connection diagram
Premasgard
LCD-SHD
Type
LCD-SHD-Modbus
LCD-SHD-xx
24 V AC / DC (±5%), 22.8 - 25.2 V AC/DC
< 1 W
0-10 V (3-wire connection)
Modbus RTU (4-wire connection)
angle plug connector DIN EN 175301- 803 - A
Sensor-dependent settings for averaging (only applies to display)
< 0,2 % final value
typically < 0.01 % final value/K
made of plastic, material polyamide, colour black, base Ø 40 mm, h/w/d
102/107/72 mm pluggable
LCD display (16x27.5 mm) with backlight, on/off/auto;
multi-line; three-digit; display can be rotated and tilted
bar (default), kPa, psi, inWC, atm, mWC
Storage -20...+75 °C
Operation 0...+60 °C
III (according to EN 60 730)
IP 65 (according to EN 60 529)*
CE conformity, electromagnetic compatibility
according to EN 61 326, EMC Directive 2014 ⁄ 30 ⁄ EU
Pressure sensor SHD ⁄ SHD - SD ⁄ SHD 692
Modbus version
Display module for pressure transmitters
©
Compatible for
SDH-U-xxx
SHD-692-U-xxx
Third-party
manufacturer
Output Article
Modbus 1301-5114-5000-200
Modbus on request
19