Publicité
Les langues disponibles
Les langues disponibles
Installation - Feed Connection
Feed Connection
1. Locate and turn off the angle stop valve on the
cold water line feeding the sink. This valve will
usually be located under the sink on the pipe
coming out of the wall.
2. When the angle stop valve is closed, relieve
pressure in the line by momentarily opening the
cold water tap on the sink.
3. Disconnect the cold water faucet feed line at the
angle stop valve.
4. Install the feed valve assembly into the angle stop.
5. Firmly press the green tubing into the connector
on the feed valve assembly.
6. Connect the cold water faucet feed line into the
feed valve assembly.
7. Make sure the small shutoff valve on the feed
valve assembly is closed.
8. Turn on the feed water connection valve.
9. Check for leaks.
10. Attach the small feed valve warning tag from the
parts bag to the feed valve.
11. Attach the Shutoff Warning label to the system so
that it is directly visible.
12. Fill out the Date of Installation label and attach to
the side of the system.
6
Kinetico KCRO+
Feed Tubing (green) connection
Shutoff valve
Adapter
Angle stop
Publicité
