Parts List; Thermal Cut-Out - Tristar VE-5952 Mode D'emploi

Partslist
1. Screw, nut
2. Front guard
3. Blade
4. Position screw
5. Rear guard
6. Power switch
7. Oscillation Knob
8. Motor
9. Power cord
10. T ube
11. Base
12. B ase Addition part
13. J oint screw
assEmbly
1. After removing everything from the carton, locate the motor unit
(item 8) and separate the front guard (item 2) and back guard
(item 5) if they are connected.
2. Locate the rear guard (item 5) and align with 4 protruding indents on
the motor unit (item 8). The safety grille will only fit one way over the
protruding intents with the handle facing up. insert 4 locking screws
(item 4) and tighten to secure the rear guard to the motor unit.
3. Locate the fan blades (item 3) and align the centre of the blades
over the metal spindle protruding from the motor unit. The intent
on the metal spindle aligns with the locking screw on the fan
blades. After the blade has been put on, tighten the locking
screw on the fan blades and ensure that the blades is secured to
the motor unit.
4
6
7
8
9
1 2 3 4 5
10
11
12
13
4. Align the front guard to the rear guard and lock into place with 3
locking tabs that are located on the guard. Locate the security
nut and bolt (item 1) and secure the front and rear guards
together with security nut and bolt. This is a safety precaution to
prevent the accidental dismantling of the fan.
5. Locate the pedestal base of the fan (item 11). Insert the base of
the stand (item 10) into the pedestal base, then fasten the base
(item 11,12) and the pole with the screws provided.
oPEration
The power switch is incorporated in the speed control switch on the
top of the fan.
• The fan can operate in oscillation or static mode.
• To make the fan head oscillate, push down the Oscillation Knob.
• To stop the fan head from oscillating, pull-up the Oscillation Knob.
• The head of the fan can be adjusted up or down, to do this loosen
the adjusting knob, adjust the fan to the desired angle, to secure
tighten the adjusting knob.

thErmal cut-out

A Thermal protector device was mounted in the motor. When overheats
due to various reasons, the temperature of the motor reaches the
fusing point, it will cut off automatically, make the fan safe efficiently.
When the protector is fused, the fan should be eliminated trouble and
replace a new thermal protector before the fan is used again.