SilverCrest 339566 1910 Mode D'emploi page 38

NOTE
► If you realise that you need more wax than you have melted,
you can add additional wax discs 9 to the inner bowl 1.
Wait until the wax has melted before you start epilating.
Melt a maximum of 6 wax discs 9 at once.
►
Epilation
The skin regions that you want to epilate should be dry, clean and
free of care products, oils or fats.
NOTES
► Before first use, carry out a skin test to find out whether your
skin reacts to the treatment. Apply a small amount of melted
wax to an inconspicuous area of skin. After removing the
wax, check to see whether the skin reacts in any way over
the course of the next 24 hours. If you notice any skin reac-
tions, stop using this appliance. If in any doubt, seek medical
advice.
► If you have a tendency towards ingrowing hairs, carry out
regular peelings. These can prevent the hairs from growing
inwards.
► Always pull off the wax strips as close as possible to the skin
surface.
► Make sure that you don't get any wax on your clothes. Wax
residue can be very difficult to remove and may discolour
clothing.
SWWS 240 C1
GB │ IE │
35 ■