EINHELL TC-SB 245 L Instructions D'origine page 22

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols used (see Fig. 25)
1. Danger! - Read the operating instructions to
reduce the risk of injury.
2. Caution! Wear ear-muff s. The impact of noi-
se can cause damage to hearing.
3. Caution! Wear a breathing mask. Dust
which is injurious to health can be generated
when working on wood and other materials.
Never use the device to work on any materi-
als containing asbestos!
4. Caution! Wear safety goggles. Sparks ge-
nerated during working or splinters, chips and
dust emitted by the device can cause loss of
sight.
5. Pull the power plug before beginning any
repair or maintenance work!
6. Saw blade cutting direction
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
2. Layout and items supplied
2.1 Layout (Fig. 1-24)
1. On/Off switch
2. Motor unit
3. Rubber tire
4. Rubber foot
5. Pedestal
6. Dust extraction connector
Anl_TC-SB_245_L_SPK13.indb 22 Anl_TC-SB_245_L_SPK13.indb 22
GB
7. Lower blade pulley
8. Upper blade pulley
9. Tightening screw
10. Cross stop
11. Upper blade guide
12. Side cover
13. Fastening handle
14. Saw table mount
15. Saw table
16. Angle scale
17. Table insert
18. Wing handle for saw table
19. Sleeve for saw table
20. Screw for saw table
21. Eccentric lever for parallel stop
22. Adjustment nut for parallel stop
23. Scale for parallel stop
24. Parallel stop
25. Machine frame
26. Bandsaw blade
27. Tilt guard
28. LED lamp
29. Adjustment handle for upper blade pulley
30. Wing nut
31. Adjustment wheel for blade guide
32. Locking handle for blade guide
33. Stop screw
34. Lock nut
35. Push stick
36. Push stick holder
37. Guide rail for parallel stop
38. Locking screws for guide rail
39. Top left support bearing
40. Top right support bearing
41. Top rear support bearing
42. Top bearing unit
43. 5 mm socket head screw
44. Bottom left support bearing
45. Bottom right support bearing
46. Bottom rear support bearing
47. Bottom bearing unit
48. 4 mm socket head screw
49. Opening
50. Cover
51. Push-in cover
52. Locking screw for cross stop
53. V-belt
54. 6 mm socket head screw
55. Adjustment screw
56. On/Off switch for LED lamp
57. Hex key 4 mm
58. Hex key 5 mm
- 22 -
11.01.2024 14:09:24 11.01.2024 14:09:24