Nederman 20376724 Manuel D'instructions page 16

EN Fan Start/Stop Device
3.
Press button S once. The relay function LEDs (5,1,2,3,4) (item 1), flash three times when the
receiver has found the transmitter.
4.
Relay function LED 1 (item 1) is lit.
NOTE!
receiver looses contact with the transmitter.
4.6 Reset the receiver
See section 3.2 'Main components', figures 1 and 2, and follow the procedure below:
1.
Press button F once.
2.
Press and hold button S until the function relay LEDs (5,1,2,3,4) are not lit.
The system is now unlinked, and no transmitters work with the receiver. See section 4.5 'Program
the receiver' to re-link the receiver to the transmitters.
4.7 Installation check
Follow the procedure below to check the installation. See also figures 1 and 2:
1.
Start a vehicle.
2.
Check that the transmitter LED for that vehicle lit (green). See figure 2. If the LED is lit
(red), power to that transmitter is weak; less than 6V.
3.
Check that the fan starts.
4.
The fan stops approximately 2.5 minutes after the following:
NOTE!
power, or at least that the power to transmitters is less than 1V.
5 Maintenance
Check the system at least once a month. See section 4.7 'Installation check'.
6 Recycling
The product has been designed for component materials to be recycled. Its different material types
must be handled according to relevant local regulations. Contact the distributor or Nederman if
uncertainties arise when scrapping the product at the end of its service life.
7 Spare parts
Contact your nearest authorized distributor or Nederman for advice on technical service or if you
require help with spare parts. See also www.nederman.com.
When ordering spare parts always state the following:
•
Part number and control number (see the product identification nameplate).
•
Detail number and name of the spare part (see www.nederman.com).
•
Quantity of the parts required.
16
Power LED 1 remains lit until power is disconnected to the transmitter, or the
–
The vehicle's engine is turned off.
–
The receiver looses contact with the transmitter.
If the fan does not stop, make sure all vehicles are off and that no transmitter is receiving