Ferroli DIVATOP D HF Serie Instructions D'utilisation page 61

DIVATOP D HF
2.6 Fume ducts
Important
The unit is a "C type" with sealed chamber and forced draught, the air inlet and fume outlet must be connected to one
of the following extraction/suction systems. The unit is approved for operation with all the Cny flue configurations given
on the dataplate. Some configurations may be expressly limited or not permitted by law, standards or local regulations.
Before installation, check and carefully follow the instructions. Also, comply with the instructions on the positioning of
wall and/or roof terminals and the minimum distances from windows, walls, ventilation openings, etc.
Baffles
Boiler operation requires fitting the baffles supplied with the unit. Make sure the boiler is properly fitted with the correct
baffle (if to be used).
A
2
1
A Baffle replacement with boiler not installed
B Baffle replacement with boiler and fume ducts already installed
EN
1
2
3
fig. 28- Baffle replacement
cod. 3540000180 - Rev. 02 - 06/2024
5
6
4
61