Publicité
Les langues disponibles
Les langues disponibles
Trouble or fault
Product does not develop
full power.
The accessory tool can't be
released.
Product does not start.
Service indicator shows.
Service indicator flashes.
The ON/OFF indicator flash-
es.
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶
DO NOT send batteries through the mail!
▶
Cover the terminals with a non-conductive material (such as electrical tape) to prevent short
circuiting.
▶
Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or
public health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, your old tools, machines
or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative
for further information.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!
Manufacturer's warranty
▶
Please contact your local Hilti representative if you have questions about the warranty conditions.
Further information
For more information on operation, technology, environment and recycling, follow this link:
qr.hilti.com/manual/?id=2310391&id=2310393
This link is also to be found at the end of the documentation, in the form of a QR code.
*2310391*
Possible cause
The half-power button is en-
gaged.
The tool holder is not pulled
back fully.
The side handle is not fitted cor-
rectly.
The electronic restart interlock is
activated after an interruption in
the electric supply.
Service limit time reached.
The product is faulty.
Product momentarily overload-
ed.
Protection against overheating.
2310391
Action to be taken
▶
Press the "half-power" button.
▶
Pull the tool lock back as far
as it will go and remove the
accessory tool.
▶
Disengage the side handle
and refit it correctly so that
the clamping band and side
handle engage in the recess.
▶
Switch the product off and
then on again.
▶
Have the product repaired by
Hilti Service.
▶
Have the product repaired by
Hilti Service.
▶
Release the control switch
and then press it again.
▶
Allow the product to cool
down and clean the air vents.
28
Publicité
