Hilti TE 500-22 Mode D'emploi page 28

Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
Noise information and vibration values
The sound pressure and vibration values given in these instructions were measured in accordance
with a standardized test and can be used to compare one power tool with another. They can also be
used for a preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used
for different applications, with different accessory tools, or is poorly maintained, the data can vary.
This can significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is
switched off, or when it is running but not actually being used for a job. This can significantly reduce
exposure over the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration,
for example: maintaining the power tool and accessory tools, keeping the hands warm, organization
of work patterns.
Detailed information on the versions of the EN 62841 standards applied here is to be found in
the reproduction of the declaration of conformity
Noise information
Sound pressure level (L
Uncertainty for the sound pressure level (K
Sound power level (L
Uncertainty for the sound power level (K
Total vibration
Uncertainty (K)
Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶
Before inserting the battery, make sure that the product is switched off.
▶
Remove the battery before making any adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
Charging the battery
1.Before charging the battery, read the operating instructions for the charger.
2.Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3.Use an approved charger to charge the battery.
23
)
pA
)
WA
21.6 V
See the end of these operating in-
structions
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
296.
)
pA
)
WA
1.5 m/s²
20
2310391
95 dB
3 dB
103 dB
3 dB
*2310391*