Publicité
SETTING THE CLOCK AND DELAY BREW TIME
To Set the Clock:
1. Plug the power cord into a standard electrical
outlet. The clock will flash on the control
panel to indicate that the time has not been
set yet.
2. Press and hold the HOUR and MINUTE buttons
until you reach the current time. The AM or
PM indicator will light at the left of the display
(Figures 1 and 2).
The clock is now set!
NOTE: Pressing any button before setting the
clock will cause the clock to start keeping time
from 12:00 a.m. You must set the clock if you
want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply
press the SET DELAY button (Figure 3) and, while
the DELAY BREW yellow light is flashing, set the
brew time by pressing the HOUR and MINUTE
buttons (Figure 4). The AM or PM indicator is at
the left of the clock display.
Within a few seconds the display will change
to the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle,
see the Brewing Coffee Later section.
To check the programmed time, push the SET
DELAY button. The display will show the time
you have programmed the coffee to brew. If you
press the SET DELAY button again or wait a few
seconds, the display will switch back.
F
1
IGURE
F
2
IGURE
F
3
IGURE
F
4
IGURE
9
Publicité
