Buderus B-THIW Notice D'installation Et D'utilisation page 33

1.2 Safety instructions
CAUTION
Damage due to incorrect connection.
The device may be damaged if this product is connected
incorrectly.
▶ Only have the product installed by an authorised
professional.
General
▶ Use the product only for fixed installations and fix it
securely within a fixed installation.
▶ Only operate the product indoors in a dry and dust-free
environment and protect it from constant exposure to
sunlight or heat as well as extreme humidity, cold or
mechanical stress.
▶ Do not use the product if there is any visible external
damage, e.g. to the enclosure, control elements or
connection sockets.
▶ Do not open the product. For safety reasons, unauthorised
conversion and/or modification of the product is not
permitted
The product is not a toy! Do not allow children to play with it. Do
not leave the packaging material lying around carelessly.
Plastic foils and small parts can become dangerous toys for
children.
No liability is accepted for damage property or personal injury
caused by incorrect handling or failure to observe the hazard
warnings. In such cases, all warranty claims become invalid!
With the remote control or automatic control of an appliance,
external circumstances (e.g. interrupted radio connection to
Buderus Logamatic TC100.2 or SRC plus with radio module
MX300) cannot always guarantee that commands are actually
carried out or that the correct appliance status is displayed in
the app. This may result in property damage and/or personal
injury.
Therefore:
▶ To the best possible extent, make sure that no persons are
endangered at the moment of remote operation or
automatic control.
▶ Take special care when setting up or adjusting a remote
control or automatic control and check the desired
operation at regular intervals.
B-THIW/B-THIW24 – 6721869243 (2024/08)
Explanation of symbols and safety instructions
H Electrical installation
▶ When connecting to the appliance terminals, observe the
permissible cables and cable cross-sections intended for
this purpose.
▶ Make sure that the consumers connected to the relay
outputs have sufficient insulation.
▶ When connecting a consumer, observe the technical data,
especially the maximum permissible breaking capacity of
the relay and the type of consumer to be connected. All
load specifications refer to resistive loads. Only load the
actuator up to the declared Coefficient of Performance.
▶ Overloading can lead to destruction of the product, cause a
fire or electric shock.
▶ The product is not suitable for isolating.
H Electrical installation 230 V
This product may only be installed by competent persons who
are authorised to install 230 V AC equipment.
▶ If in doubt, find out which legal regulations apply in your
country.
▶ Protect the circuit to which the product and the load are
connected with a miniature circuit breaker according to EN
60898-1 (tripping characteristic B or C, max. 16 A rated
current, min. 6 kA disconnecting capacity, energy
limitation class 3).
▶ Observe installation regulations according to HD384 or IEC
60364 as well as other national specifications,
e.g.VDE 0100. The miniature circuit breaker must be easily
accessible to the user and marked as the isolator for the
product.
H Electrical installation 24 V
▶ To ensure electrical safety: make sure that the supplying
source is a safety extra-low voltage.
1
33