AEG AC3802 Notice D'utilisation page 62

Problem
Door is misaligned or interferes with
ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and ice.
Water flows on the rear plate of the
refrigerator.
There is too much condensed water
on the rear wall of the refrigerator.
Water flows on the floor.
The temperature in the appliance is
too low/too high.
62 ENGLISH
Possible cause
Food products placed in the appli‐
ance were too warm.
The door is not closed correctly.
The appliance is not levelled.
You attempted to re-open the door
immediately after closing.
The lamp is in stand-by mode.
The lamp is defective.
The door is not closed correctly.
The gasket is deformed or dirty.
Food products are not wrapped
properly.
Temperature is set incorrectly.
Appliance is fully loaded and is set
to the lowest temperature.
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
During the automatic defrosting
process, frost melts on the rear
plate.
Door was open too frequently.
Door was not closed completely.
Stored food was not wrapped.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Solution
Allow food products to cool to room
temperature before storing.
Refer to the "Closing the door" sec‐
tion.
Refer to the installation instructions.
Wait a few seconds between closing
and re-opening of the door.
Close and open the door.
Contact the nearest Authorized
Service Centre.
Refer to the "Closing the door" sec‐
tion.
Refer to the "Closing the door" sec‐
tion.
Wrap the food products better.
Refer to the "Operation" chapter.
Set a higher temperature. Refer to
the "Operation" chapter.
Set a higher temperature. Refer to
the "Operation" chapter.
This is correct. Dry the water with a
soft cloth.
Open the door only when necessa‐
ry.
Make sure the door is closed com‐
pletely.
Wrap food in suitable packaging be‐
fore storing it in the appliance.
Attach the melting water outlet to
the evaporative tray.
Refer to the "Closing the door" sec‐
tion.
Let the food products temperature
decrease to room temperature be‐
fore storage.